We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Airframe & engine
FAA Registry + type data
Airframe
Manufacturer
Cessna
Model
550
Serial number
550-0109
Aircraft type
Fixed wing multi engine
Category
Land
Certification
Type Certificated
Seats
8
Engines
2
Max takeoff weight
12,500 - 19,999 lb
Mode S code
AA2563
Engine
Type
Turbo-fan
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Ownership history
Ownership history from FAA records
1980 – 2015U S Department Of Homeland SecurityWashington, DC
Individual owners are shown by city and state only.
Safety record
NTSB · Oct 15, 2026 · FAA ADs · Oct 17, 2026 · SDRs · Oct 16, 2026
NTSB events (1)
Accident · substantial damage
Dec 21, 2012 · Oklahoma City, OK
The flight crew's decision to fly close behind a heavy airplane, which did not ensure there was adequate distance and time in order to avoid a wake turbulence encounter with the preceding heavy airplane’s wake vortex, which resulted in a loss of airplane control during final approach.
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
Cessna Model 500, 501, 550, 551, S550, 560, 560XL, and 750 Airplanes
Jul 6, 2007
Airframe (550)Serial numbers per Cessna Service Bulletins SB500-26-02, SB550-26-05, SB560-26-01, SB560XL-26-02, SB750-26-05, SBS550-26-02 (Table 1 of this AD)
Cessna Model 441, 500, 550, and 560 Series Airplanes
Jan 22, 1996
Airframe (550)Serial numbers per Allied Signal Aerospace Service Bulletins 103576-21-4054, 103576-21-4056, and 103648-21-4055. Only with: Equipped with Allied Signal outflow/safety valves identified in Allied Signal Aerospace Service Bulletins 103576-21-4054, 103576-21-4056, and 103648-21-4055.
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (1)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
Landing gear · tire · failedAug 14, 2001
DURING A DAILY INSPECTION THE SIDE WALL WAS FOUND TORN OUT WHERE THE SIDE WALL AND TIRE TRED ARE BONDED TOGOTHER. THERE IS ANOTHER AREA APROX. 6 INCHES AWAY FROM THIS TEAR, WHERE YOU CAN SEE THAT THE RUBBER IS ALSO STARTING TO SEPERATE. THE INNER AREA OF THE TEAR HAS SOFT RUBBBER COMMING OUT IT…
From FAA Service Difficulty Reports; matched by N-number and serial number.