N716SM1977 Cessna 441
Safety record in brief:No NTSB accidents or incidents since 19825 ADs may apply3 service difficulty reports
Registration
FAA Aircraft Registry · Oct 17, 2026- Registered owner
- Conquest Flight LLC
- Owner type
- LLC
- City, state
- Pottstown, PA
- Certificate issued
- Jan 28, 2005
- Expires
- Apr 30, 2029
- Airworthiness
- Standard · Normal
- Airworthiness date
- Mar 16, 1978
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Airframe & engine
FAA Registry + type dataAirframe
- Manufacturer
- Cessna
- Model
- 441
- Year
- 1977
- Serial number
- 441-0004
- Aircraft type
- Fixed wing multi engine
- Category
- Land
- Certification
- Type Certificated
- Seats
- 10
- Engines
- 2
- Max takeoff weight
- Up to 12,499 lb
- Mode S code
- A993F3
Engine
- Make and model
- Airesearch Tpe331 Series
- Type
- Turbo-prop
- Power
- 904 hp
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Ownership history
Ownership history from FAA records- 2005 – nowConquest Flight LLCPottstown, PA · current
Individual owners are shown by city and state only.
Safety record
NTSB · Oct 15, 2026 · FAA ADs · Oct 17, 2026 · SDRs · Oct 16, 2026NTSB events (0)
No NTSB accidents or incidents found for this airframe since 1982.
Accident history for this modelADs published since 1998 that may apply (5)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2005-20-25 | The Cessna Aircraft Company Models 401, 401A, 401B, 402, 402A, 402B, 402C, 404, 411… | Nov 9, 2005 | Airframe (441)Certain serial numbers: 401 655; 401 401-0001–401-0322; 401A 655; 401A 401A0001–401A0132; 401B 401B0001–401B0221; 402 402-0001–402-0322; …. Only with: Equipped with an avionics bus circuit breaker switch P/N CM3589-50, 593-250-101, 593-250-102, W31-X2M5A-50, or W31-X1000-50. |
| 2003-09-09 | Cessna Aircraft Company Models 441 and F406 Airplanes | Jun 24, 2003 | Airframe (441)Certain serial numbers: 441 0001–0362; 441 698; F406 0001–0089 |
| 98-04-28 | Cessna Aircraft Company Models T303, 310R, T310R, 335, 340A, 402B, 402C, 404, F406, 414… | Mar 13, 1998 | Airframe (441) |
| 97-25-04 | Cessna Aircraft Company Models 208, 208A, 208B, 425, and 441 Airplanes | Jan 21, 1998 | Airframe (441) |
| 95-25-10 | Cessna Model 441, 500, 550, and 560 Series Airplanes | Jan 22, 1996 | Airframe (441)Serial numbers per Allied Signal Aerospace Service Bulletins 103576-21-4054, 103576-21-4056, and 103648-21-4055. Only with: Equipped with Allied Signal outflow/safety valves identified in Allied Signal Aerospace Service Bulletins 103576-21-4054, 103576-21-4056, and 103648-21-4055. |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (3)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
- Hydraulic power · line · failedFeb 3, 2017
HYDRAULIC LINE, HIGH PRESSURE, OPERATES LANDING GEAR AND FLAPS. THIS OPERATOR HAS SEEN THIS SAME HARD HYDRAULIC LINE FAIL, HIGH PRESSURE LEAK , ON OTHER C441 ACFT ALONG WITH OTHER HYDRAULIC LINES AFT OF FIRE WALL.
From FAA Service Difficulty Reports; matched by N-number and serial number. - Landing gear · bellcrank · deformedMar 29, 2013
THE NOSE GEAR TRAPEZE (BELLCRANK) BECAME DEFORMED, PROBABLY FROM THE GEAR DOOR RETRACT RAMP DURING RETRACTION. THE NOSE UNSAFE LIGHT REMAINED ILLUMINATED AND EXTENTION WAS SELECTED. 3 GREENS AND DOWNLOCK WERE ACHIEVED AND AN UNEVENTFUL LANDING FOLLOWED. BOTH THE RAMP (5742204-2) AND TRAPEZE…
From FAA Service Difficulty Reports; matched by N-number and serial number. - Hydraulic power · line · failedAug 2, 2007
THE LT FIRE WALL TO WING ROOT (RESEVOIR) HIGH PRESSURE HYDRAULIC LINE DEVELOPED A CRACK IN THE BEND RADIUS NEAR THE ATTACH FITTING TO THE FIREWALL. A FACTORY REPLACEMENT LINE WAS INSTALLED. THIS OPERATOR FEELS THIS IS DUE TO THE AGE OF THE FLEET ALONG WITH THE FACTORY BENDING MANDREL. (K)
From FAA Service Difficulty Reports; matched by N-number and serial number.
Sources
- FAA Aircraft RegistryRegistration, owner city and state, airframe, engineupdated Oct 17, 2026
- NTSB accident and incident databaseAccidents and incidents since 1982updated Oct 15, 2026
- FAA Airworthiness Directives (Federal Register)ADs published since 1998updated Oct 17, 2026
- FAA Service Difficulty ReportsReports since 1995updated Oct 16, 2026