This N-number isn't registered right now. Below is its last known registration, canceled Feb 27, 2018.
Safety record in brief:1 NTSB accident (substantial damage, Jan 2014)4 ADs may apply1 service difficulty report
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Individual owners are shown by city and state only.
Airport personnel did not remove the snow banks from the intersecting runway and/or close the intersection runway, which resulted in the airplane impacting the snow banks. Contributing to the accident was the reduced visibility inhibiting the pilot's ability to see the plowed snow hazard.
From NTSB records; matched by serial number.Read NTSB report (search CAROL for CEN14CA114)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2016-17-08 | Elevator Tab Control System | Sep 12, 2016 | Airframe (340) |
| 2014-03-03 | Cessna Aircraft Company Airplanes | Apr 7, 2014 | Airframe (340)Serial numbers per Cessna Aircraft Company Service Bulletin MEB97-4, dated March 24, 1997 |
| 2009-16-03 | Teledyne Continental Motors (TCM) IO-520, TSIO-520, and IO-550 Series Reciprocating… | Sep 9, 2009 | Engine (TSIO-520 SER)Only with: SAP investment cast cylinder assemblies P/Ns SA52000-A1, SA52000-A20P, SA52000-A21P, SA52000-A22P, SA52000-A23P, SA55000-A1, or SA55000-A20P installed. |
| 2000-01-16 | Cessna Aircraft Company 300 and 400 Series Airplanes | Feb 15, 2000 | Airframe (340) |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
DURING INSTALLATION OF FUEL LINE CROSSFEED KIT NR SK340-31-6, REMOVAL OF THE OLD LINES REVEALED THAT TWO LINES HAD NEARLY BEEN WORN THROUGH DUE TO CONTACT WITH INSPECTION PANEL SCREWS. THE ORIGINAL TUBING WAS PROTECTED BY THE ABRASION CUSHIONS, BUT THE EXTENT OF DAMAGE WAS NOT EVIDENT UNTIL THE…
From FAA Service Difficulty Reports; matched by N-number and serial number.