We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Airframe & engine
FAA Registry + type data
Airframe
Manufacturer
Hughes
Model
HUGHES 369D
Year
1982
Serial number
1103D
Aircraft type
Rotorcraft
Category
Land
Certification
Type Certificated
Seats
4
Engines
1
Max takeoff weight
Up to 12,499 lb
Type certificate data sheet
H3WE
Mode S code
A66F8C
Engine
Make and model
Allison 250-C20 Ser
Type
Turbo-shaft
Power
420 hp
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Ownership history
Ownership history from FAA records
1982 – nowTemsco Helicopters INCKetchikan, AK · current
Individual owners are shown by city and state only.
Safety record
NTSB · Oct 15, 2026 · FAA ADs · Oct 20, 2026 · SDRs · Oct 16, 2026
NTSB events (1)
Accident · substantial damage
Mar 3, 2007 · Gustavus, AK
The inadequate clearance from a tranquilized moose while hovering in ground effect, and the operator's inadequate procedures for such operations, which resulted in an in-flight collision with the moose. Factors associated with the accident were the moose, a sheared tail rotor drive shaft, and the resultant lack of tail rotor anti-torque control.
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
Engine (250-C20 SER)Only with: Engines that do not have turbine energy absorbing ring RRC P/N 23035175, or an equivalent FAA-approved serviceable ring, installed.
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (1)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
Tail rotor · gearbox · making metalAug 2, 2004
PILOT REPORTED A CHIP LIGHT FOR THE TAIL ROTOR GEAR BOX. MECHANIC INVESTIGATED AND FOUND FOUR HAIR LINE SLIVERS ON THE CHIP PLUG ALL WHICH EXCEEDED LIMITS AS DESCRIBED BY THE MM. REMOVED THE GEAR BOX (PN 369D25400 SN 0295) AND INSTALLED SERVICEABLE GEAR BOX WITH SAME PN AND SN 0022220081.…
From FAA Service Difficulty Reports; matched by N-number and serial number.