This N-number isn't registered right now. Below is its last known registration, canceled Jun 4, 2018.
Safety record in brief:1 NTSB accident (substantial damage, Jul 2009)5 ADs may apply3 service difficulty reports
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Individual owners are shown by city and state only.
A malfunction of the landing gear selector switch and a loose fitting on the emergency extension system which rendered the landing gear system inoperable.
From NTSB records; matched by serial number.Read NTSB report (search CAROL for CEN09LA415)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2005-20-25 | The Cessna Aircraft Company Models 401, 401A, 401B, 402, 402A, 402B, 402C, 404, 411… | Nov 9, 2005 | Airframe (441)Certain serial numbers: 401 655; 401 401-0001–401-0322; 401A 655; 401A 401A0001–401A0132; 401B 401B0001–401B0221; 402 402-0001–402-0322; …. Only with: Equipped with an avionics bus circuit breaker switch P/N CM3589-50, 593-250-101, 593-250-102, W31-X2M5A-50, or W31-X1000-50. |
| 2003-09-09 | Cessna Aircraft Company Models 441 and F406 Airplanes | Jun 24, 2003 | Airframe (441)Certain serial numbers: 441 0001–0362; 441 698; F406 0001–0089 |
| 98-04-28 | Cessna Aircraft Company Models T303, 310R, T310R, 335, 340A, 402B, 402C, 404, F406, 414… | Mar 13, 1998 | Airframe (441) |
| 97-25-04 | Cessna Aircraft Company Models 208, 208A, 208B, 425, and 441 Airplanes | Jan 21, 1998 | Airframe (441) |
| 95-25-10 | Cessna Model 441, 500, 550, and 560 Series Airplanes | Jan 22, 1996 | Airframe (441)Serial numbers per Allied Signal Aerospace Service Bulletins 103576-21-4054, 103576-21-4056, and 103648-21-4055. Only with: Equipped with Allied Signal outflow/safety valves identified in Allied Signal Aerospace Service Bulletins 103576-21-4054, 103576-21-4056, and 103648-21-4055. |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
THIS MLG CONTROL VALVE FOUND TO BE REASON THE MLG FAILED A SCHEDULED EMERGENCY EXTENTION CHECK. FOUND THE RETURN PORT CLOSED WHEN VALVE NOT ENERGIZED, PORT SHOULD BE OPEN IN THIS CONDITION & THIS CAUSED MLG TO HYDRO-LOCK IN UP POSITION. TEAR DOWN REVEALED ON 2ND VALVE NOT ASSEMBLED CORRECTLY…
From FAA Service Difficulty Reports; matched by N-number and serial number.DUE TO SLOTTED PIN FAILURE OF THE OTHER GEAR THIS PIN WAS INSPECTED AND FOUND TO BE PARTIALLY SHEARED. PIN WAS REPLACED WITH NEW NAS561P628 PIN. THE AFT TRUNION SLOTTED PINS ON BOTH MAIN GEAR WERE INSPECTED WITH NO DEFECTS NOTED BUT WERE REPLACED WITH NEW. PIN WAS LOCATED ON THE FORWARD POSITION…
From FAA Service Difficulty Reports; matched by N-number and serial number.PREFLIGHT INSPECTION FOUND LANDING GEAR PIVOT PIN BACKED OUT OF TRUNION DUE TO SLOTTED PIN BEING SHEARED. SAFETY WIRE USED TO RETAIN PIN WAS ALSO SHEARED BUT DUE TO ITS LENGTH AND DIAMETER. IT STAYED IN THE TRUNION GIVING THE IMPRESSION THAT IT WAS SECURE. LT MAIN LANDING GEAR FORWARD PIVOT PIN.
From FAA Service Difficulty Reports; matched by N-number and serial number.