N492CMeyers Industries INC 200A
Safety record in brief:No NTSB accidents or incidents since 1982No ADs since 1998 matched2 service difficulty reports
Registration
FAA Aircraft Registry · Oct 18, 2026- Registered owner
- Individual owner
- City, state
- Milaca, MN
- Certificate issued
- Jun 3, 2025
- Expires
- Jun 30, 2032
- Airworthiness
- Standard · Normal
- Airworthiness date
- Aug 6, 1975
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Airframe & engine
FAA Registry + type dataAirframe
- Manufacturer
- Meyers Industries INC
- Model
- 200A
- Serial number
- 256
- Aircraft type
- Fixed wing single engine
- Category
- Land
- Certification
- Type Certificated
- Seats
- 4
- Engines
- 1
- Max takeoff weight
- Up to 12,499 lb
- Mode S code
- A617B8
Engine
- Make and model
- Ama/Expr Unknown Eng
- Type
- Reciprocating
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Ownership history
Ownership history from FAA records- 2025 – nowIndividual ownerMilaca, MN · current
Individual owners are shown by city and state only.
Safety record
NTSB · Oct 15, 2026 · FAA ADs · Oct 18, 2026 · SDRs · Oct 16, 2026NTSB events (0)
No NTSB accidents or incidents found for this airframe since 1982.
Accident history for this modelADs published since 1998 that may apply (0)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
No ADs published since 1998 matched this airframe or engine model.
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (2)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
- Landing gear · control cable · misinstalledJun 22, 1995
RIGHT MAIN GEAR FAILED TO EXTEND. INVESTIGATION REVEALED THE WHEEL BAIL CABLE WAS PREVIOUSLY REPLACED. THE CABLE WAS 2 INCHES TOO SHORT AND THE WRONG SWAGED TERMINAL WAS INSTALLED ALLOWING THE CABLE TO BIND AT THE ATTACHMENT. THIS BINDING, AND SHORTNESS, CAUSED THE CABLE TO PREVENT THE INBOARD…
From FAA Service Difficulty Reports; matched by N-number and serial number. - Landing gear · wheel bail cable · attach incorrectJun 22, 1995
RIGHT GEAR, INBOARD DOOR WHEEL BAIL CABLE ATTACH POINT INSTALLED IN THE WRONG POSITION. ATTACH POINT WAS LOCATED ON THE TOP OF THE BAIL APPROXIMATELY 2 INCHES FORWARD OF THE AFT CORNER. PROPER POSITION SHOULD BE APPROXMATELY AT THE AFT CORNER.
From FAA Service Difficulty Reports; matched by N-number and serial number.
Sources
- FAA Aircraft RegistryRegistration, owner city and state, airframe, engineupdated Oct 18, 2026
- NTSB accident and incident databaseAccidents and incidents since 1982updated Oct 15, 2026
- FAA Airworthiness Directives (Federal Register)ADs published since 1998updated Oct 18, 2026
- FAA Service Difficulty ReportsReports since 1995updated Oct 16, 2026