Safety record in brief:1 NTSB accident (substantial damage, Mar 2002)9 ADs may apply4 service difficulty reports
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Individual owners are shown by city and state only.
The failure of the left main landing gear scissors assembly which resulted from improper maintenance.
From NTSB records; matched by serial number.Read NTSB report (search CAROL for FTW02LA091)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2017-10-09 | Textron Aviation Inc. Airplanes | Jun 7, 2017 | Airframe (402C)Certain serial numbers: 402C 402C0001–402C1020; 414A 414A0001–414A1212. Only with: Equipped with Cessna Multi-Engine Service Kit SK402-47 (Original Issue, Rev A, or Rev B) or nacelle fittings P/Ns 5292029-9, -10, -11, -12, -21, -22, -23, or -24. |
| 2016-17-08 | Elevator Tab Control System | Sep 12, 2016 | Airframe (402C) |
| 2015-07-03 | Nacelles/Pylons | Apr 24, 2015 | Airframe (402C)Certain serial numbers: 402C 402C0001–402C1020; 414A 414A0001–414A1212 |
| 2012-23-01 | Wings | Dec 26, 2012 | Airframe (402C)Only with: Model 402C modified by STC SA927NW; Model 414A modified by STC SA892NW. |
| 2009-16-03 | Teledyne Continental Motors (TCM) IO-520, TSIO-520, and IO-550 Series Reciprocating… | Sep 9, 2009 | Engine (TSIO-520 SER)Only with: SAP investment cast cylinder assemblies P/Ns SA52000-A1, SA52000-A20P, SA52000-A21P, SA52000-A22P, SA52000-A23P, SA55000-A1, or SA55000-A20P installed. |
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2005-20-25 | The Cessna Aircraft Company Models 401, 401A, 401B, 402, 402A, 402B, 402C, 404, 411… | Nov 9, 2005 | Airframe (402C)Certain serial numbers: 401 655; 401 401-0001–401-0322; 401A 655; 401A 401A0001–401A0132; 401B 401B0001–401B0221; 402 402-0001–402-0322; …. Only with: Equipped with an avionics bus circuit breaker switch P/N CM3589-50, 593-250-101, 593-250-102, W31-X2M5A-50, or W31-X1000-50. |
| 2005-12-13 | Cessna Aircraft Company Models 402C and 414A Airplanes | Jun 22, 2005 | Airframe (402C) |
| 2000-01-16 | Cessna Aircraft Company 300 and 400 Series Airplanes | Feb 15, 2000 | Airframe (402C) |
| 98-04-28 | Cessna Aircraft Company Models T303, 310R, T310R, 335, 340A, 402B, 402C, 404, F406, 414… | Mar 13, 1998 | Airframe (402C) |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
NR 4 CYLINDER'S CONNECTING ROD END CAP SEPARATED FROM CONNECTING ROD. INSPECTION OF ENGINE REVEALED THAT 1 OF THE 2 ATTACHMENT NUTS THAT SECURES END CAP TO CONNECTING ROD CRACKED INTO 4 PIECES ALLOWING END CAP TO STOP SECURING CONNECTING ROD TO CRANKSHAFT. CONNECTING ROD WAS FOUND INTACT. END CAP…
From FAA Service Difficulty Reports; matched by N-number and serial number.UPON INSPECTION OF LANDING GEAR SYSTEM, THE NOSE GEAR DOOR BELLCRANK WAS FOUND CRACKED AT LEFT DOOR EAR. THE NOSE GEAR DOORS WERE IMPROPERLY RIGGED CAUSING EXCESIVE STRESS ON BELLCRANK.
From FAA Service Difficulty Reports; matched by N-number and serial number.DURING FLIGHT AT 10,000 MSL, PILOT NOTICED THAT OIL PRESSURE ON RIGHT ENGINE WAS DROPPING SLOWLY AND OIL TEMP WAS RISING SLOWLY FOLLOWED SHORTLY BY A COMPLETE LOSS OF MANIFOLD PRESSURE. THE PILOT TOOK PRECAUTIONARY MEASURES AND SHUT DOWN ENGINE. HE CONTINUED ON AND MADE AN UNEVENTFUL SINGLE ENGINE…
From FAA Service Difficulty Reports; matched by N-number and serial number.PILOT REPORTED NOSE GEAR WOULD NOT COME DOWN AND LOCK. A NOSE GEAR UP LANDING WAS MADE. INVESTIGATION REVEALED THE FORWARD LT NOSE GEAR GOOD RETRACTION ROD BRACKET ASSY FAILED ALLOWING THE NOSE GEAR TO IMPACT DOOR ON RETRACTION AND JAMMING NOSE GEAR IN WHEEL WELL. REASON FOR BRACKET FAILURE IS NOT…
From FAA Service Difficulty Reports; matched by N-number and serial number.