PILOT IN COMMAND'S FAILURE TO SEE AND AVOID WIRES DURING THE FINAL STAGE OF AN APPROACH TO A CONFINED AREA. A CONTRIBUTING FACTOR TO THE ACCIDENT WAS THE PILOT'S DISREGARD OF THE OPERATOR'S INSTRUCTIONS AFTER HE LANDED THE FIRST TIME.
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
The Enstrom Helicopter Corporation Model F-28, F-28A, F-28C, F-28C-2, F-28F, 280, 280C…
Mar 19, 1996
Airframe (F-28A)
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (1)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
Reciprocating engine · drive belt · frayedNov 11, 2011
BELT WAS FOUND TO BE FRAYED ABOUT .5" IN FROM THE AFT SIDE, THE ENTIRE LENGTH OF BELT. PILOT STATED BELT WAS IN GOOD CONDITION WHEN ACFT WAS PREFLIGHTED ABOUT AN HOUR PRIOR TO THE FAILURE. HE HEARD A "POP" AND RETURNED TO THE HANGAR TO FIND RUBBER CHIPS AND FINE STRING FIBERS ALL OVER THE BELT…
From FAA Service Difficulty Reports; matched by N-number and serial number.