N11CQ1984 Bell 206B-III
Safety record in brief:No NTSB accidents or incidents since 19824 ADs may apply1 service difficulty report
Registration
FAA Aircraft Registry · Oct 19, 2026- Registered owner
- Scotts Helicopter Service INC
- Owner type
- Corporation
- City, state
- Le Sueur, MN
- Certificate issued
- Aug 9, 2007
- Expires
- Jan 31, 2028
- Airworthiness
- Restricted · Agriculture and Pest Control
- Airworthiness date
- Apr 6, 2016
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Airframe & engine
FAA Registry + type dataAirframe
- Manufacturer
- Bell
- Model
- 206B-III
- Year
- 1984
- Serial number
- 3778
- Aircraft type
- Rotorcraft
- Category
- Land
- Certification
- Type Certificated
- Seats
- 5
- Engines
- 1
- Max takeoff weight
- Up to 12,499 lb
- Type certificate data sheet
- H2SW
- Mode S code
- A02A1B
Engine
- Make and model
- Allison 250-C20j
- Type
- Turbo-shaft
- Power
- 420 hp
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Ownership history
Ownership history from FAA records- 2007 – nowScotts Helicopter Service INCLe Sueur, MN · current
Individual owners are shown by city and state only.
Safety record
NTSB · Oct 15, 2026 · FAA ADs · Oct 19, 2026 · SDRs · Oct 16, 2026NTSB events (0)
No NTSB accidents or incidents found for this airframe since 1982.
Accident history for this modelADs published since 1998 that may apply (4)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2009-07-52 | Bell Helicopter Textron Canada Limited Model 206A Series, 206B Series, 206L Series, 407… | May 1, 2009 | Airframe (206B-III)Only with: Model 206A/206B/206L series with cyclic control lever assembly P/N 206-001-401-111, 206-001-400-115, or 206-001-400-111, and Model 407/427 with lever assembly P/N 407-001-320-105 or 407-001-320-109, with less than 50 hours TIS. |
| 2006-16-04 | Rolls-Royce Corporation (Formerly Allison Engine Company, Allison Gas Turbine Division… | Sep 7, 2006 | Engine (250-C20J) |
| 2006-13-06 | Rolls-Royce Corporation (Formerly Allison Engine Company, Allison Gas Turbine Division… | Jul 26, 2006 | Engine (250-C20J)Only with: Engines with gas producer rotor assembly tie bolt P/Ns A23008020, E23008020 (EXTEX), 23008020, 6843388, 6876991 (RRC), A23008020 (SAP), or 23008020P (Pacific Sky Supply) installed. |
| 2005-10-13 | Rolls-Royce Corporation (Formerly Allison Engine Company) 250-B17B, -B17C, -B17D, -B17E… | Jun 22, 2005 | Engine (250-C20J)Only with: Engines that do not have turbine energy absorbing ring RRC P/N 23035175, or an equivalent FAA-approved serviceable ring, installed. |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (1)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
- Tail rotor drive · duplex bearing · roughSep 4, 1996
COULD NOT BALANCE T/R DUE TO ROUGH BEARING GIVING FALSE SIGNALS TO BALANCE EQUIPMENT. REPLACED BEARING AND REINSTALLED GEARBOX ON AIRCRAFT AND BALANCED T/R IN NORMAL MANNER WITH GOOD RESULTS.
From FAA Service Difficulty Reports; matched by N-number and serial number.
Sources
- FAA Aircraft RegistryRegistration, owner city and state, airframe, engineupdated Oct 19, 2026
- NTSB accident and incident databaseAccidents and incidents since 1982updated Oct 15, 2026
- FAA Airworthiness Directives (Federal Register)ADs published since 1998updated Oct 19, 2026
- FAA Service Difficulty ReportsReports since 1995updated Oct 16, 2026