These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
No ADs published since 1998 matched this airframe or engine model.
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (1)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
Flight controls · control cable · brokenJun 3, 1997
LOWER ELEVATOR CABLE SEPARATED IN-FLIGHT. CAUSE OF SEPARATION WAS USE OF NON-FLEXIBLE CABLE IN A REPAIR SPLICE. CABLE WORK HARDENED AND BROKE WHERE IT WENT AROUND THE PULLEY. THIS IS A KNOWN HIGH WEAR POINT ON PA-18-150. AN INSPECTION HOLE SHOULD BE INSTALLED OVER THIS POSITION FOR EASE OF…
From FAA Service Difficulty Reports; matched by N-number and serial number.