We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Airframe & engine
FAA Registry + type data
Airframe
Manufacturer
Mooney
Model
M20J
Year
1981
Serial number
24-1184
Aircraft type
Fixed wing single engine
Category
Land
Certification
Type Certificated
Seats
4
Engines
1
Max takeoff weight
Up to 12,499 lb
Mode S code
ACA2A5
Engine
Make and model
Lycoming I0360 Ser A&C
Type
Reciprocating
Power
200 hp
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Ownership history
Ownership history from FAA records
2022 – nowIndividual ownerAlbuquerque, NM · current
Individual owners are shown by city and state only.
Safety record
NTSB · Oct 15, 2026 · FAA ADs · Oct 20, 2026 · SDRs · Oct 16, 2026
NTSB events (1)
Accident · substantial damage
Sep 1, 1984 · Key Largo, FL
ACFT WAS LANDED DOWNWIND AND TOUCHED DOWN APRX HALF WAY DOWN THE RWY. THE PLT IN AN ATTEMPT TO AVOID AN OVERRUN INTENTIONALLY GROUND LOOPED THE ACFT RESULTING IN A LEFT MAIN GEAR COLLAPSE.
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
Airframe (M20J)Only with: Equipped with an O & N Bladder Fuel Cell installed per STC SA2277CE or STC SA2350CE (for M20B, incorporated by field approval).
Airframe (M20J)Certain serial numbers: M20J 24-0001–24-3250; M20J 24-3252–24-3374
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (1)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
Flight controls · torque tube · wornMar 2, 2006
EMPENNAGE TRIM CONTROL TORQUE FOUND TO HAVE A DEEP GROOVE FROM WEARING ON CAT TRACK/GROMMET WHERE IT PASSES THROUGH STIFFENERS. THIS TUBE WAS ALSO WELD REPAIRED AT SOME TIME PREVIOUS THEN SWAPPED END FOR END SO TUBE WOULD WEAR ON A NEW SURFACE. IT APPEARS THIS WAS DONE DURING AN AIRCRAFT REPAIR…
From FAA Service Difficulty Reports; matched by N-number and serial number.