This N-number isn't registered right now. Below is its last known registration, canceled Apr 4, 2023.
Safety record in brief:1 NTSB accident (substantial damage, Jul 2008)6 ADs may apply1 service difficulty report
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Individual owners are shown by city and state only.
The unsuitable terrain encountered by the pilot during a forced landing following a loss of engine power due to a cylinder head separation. Contributing to the accident was the tree.
From NTSB records; matched by serial number.Read NTSB report (search CAROL for CHI08CA203)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2018-02-01 | The Enstrom Helicopter Corporation Helicopters | Feb 21, 2018 | Airframe (F-28F)Certain serial numbers: 480 5001–5006. Only with: With main rotor spindle P/N 28-14282-11 or 28-14282-13 installed. |
| 2017-26-03 | The Enstrom Helicopter Corporation Helicopters | Jan 4, 2018 | Airframe (F-28F)Only with: Rod end bearing assembly P/N 01-824-08E-011, 09455-01-824-08E-011, ECD091-1, ASMK8T, M81935/1-08K, MS21242S8K, or MTK8 installed. |
| 2012-11-05 | Enstrom Helicopter Corporation Helicopters | Jul 3, 2012 | Airframe (F-28F)Only with: Helicopters with trim relay P/N KUP14D55-24, KUP14D55-472, M83536/10-015M, or M83536/10-024M installed; does not apply to helicopters with reversible trim motor P/N 28-16621 or P/N AD1R-10. |
| 2011-26-10 | Enstrom Helicopter Corporation Helicopters | Jan 23, 2012 | Airframe (F-28F)Only with: Helicopters with a trim relay P/N KUP14D55-472, M83536/10-015M, or M83536/10-024M installed; does not apply to helicopters with reversible trim motor P/N 28-16621 or AD1R-10. |
| 2002-08-03 | Enstrom Helicopter Corporation Model F-28, F-28A, F-28C, F-28F, 280, 280C, 280F, and… | May 2, 2002 | Airframe (F-28F) |
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 96-06-03 | The Enstrom Helicopter Corporation Model F-28, F-28A, F-28C, F-28C-2, F-28F, 280, 280C… | Mar 19, 1996 | Airframe (F-28F) |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
DURING CYLINDER OVERHAUL A DAMAGE SEAT POCKET CUTTER USE USED. THIS RESULTED IN A VALVE SEAT POCKET THAT MEASURED WITHIN LIMITS BUT LACKED THE PROPER SURFACE CONTACT. AFTER APPROXIMATELY 3 HOURS OF ENGINE OPERATION, THE VALVE SEAT CAME OUT CAUSING THE INTAKE VALVE TO BREAK. THIS CAUSED A LOSS OF…
From FAA Service Difficulty Reports; matched by N-number and serial number.