Skip to content
KnownTail
Aircraft record

N787MW1976 Bellanca 7ECA

DeregisteredUnclaimedSource: FAA, updated Oct 18, 2026

This N-number isn't registered right now. Below is its last known registration, canceled May 31, 2018.

Safety record in brief:1 NTSB accident (substantial damage, Sep 2016)3 ADs may apply

Registration
Deregistered
Last based in
Crystal, MN
owner city / state
Owners
1
on record
NTSB events
1
substantial, 2016
ADs may apply
3
confirm with A&P
Service reports
0
since 1995

Registration

FAA Aircraft Registry · Oct 18, 2026
Last registered owner
Individual owner
City, state
Crystal, MN
Canceled
May 31, 2018
Airworthiness
Standard · Normal, Acrobatic
Airworthiness date
Aug 23, 1976

We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.

Airframe & engine

FAA Registry + type data

Airframe

Manufacturer
Bellanca
Model
7ECA
Year
1976
Serial number
1177-76
Aircraft type
Fixed wing single engine
Category
Land
Certification
Type Certificated
Seats
2
Engines
1
Max takeoff weight
Up to 12,499 lb
Mode S code
AAABAF

Engine

Make and model
Lycoming 0-235 Series
Type
Reciprocating
Power
115 hp

Total time and engine hours aren't public. They appear here once the owner adds logbooks.

Ownership history

Ownership history from FAA records
  1. until 2018Individual ownerCrystal, MN

Individual owners are shown by city and state only.

Safety record

NTSB · Oct 15, 2026 · FAA ADs · Oct 18, 2026 · SDRs · Oct 16, 2026

NTSB events (1)

Accident · substantial damage

Sep 4, 2016 · Moss Hill, TX

The pilot's loss of control attempting to recover from a low-level aerobatic maneuver. Contributing to the accident was the pilot's decision to attempt the low-level maneuver which significantly reduced any margin for error.

Damage
Substantial
Injuries
Fatal
Report
CEN16FA346

From NTSB records; matched by serial number.Read NTSB report (search CAROL for CEN16FA346)

Accident history for this model

ADs published since 1998 that may apply (3)

These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.

ADSubjectEffectiveApplies to
2009-22-02American Champion Aircraft Corp. Models 7ECA, 7GCAA, 7GCBC, 7KCAB, 8KCAB, and 8GCBC…Dec 3, 2009Airframe (7ECA)Only with: Manufactured prior to 1989 and equipped with folding rear seat backs.
2005-24-10American Champion Aircraft Corporation Models 7AC, 7ACA, S7AC, 7BCM, 7CCM, S7CCM, 7DC…Jan 17, 2006Airframe (7ECA)Only with: Models 7ECA, 7GCAA, 7GCBC, 8KCAB, 8GCBC manufactured before August 12, 2005 with less than 250 hours TIS; or any listed model with a flight control cable (or wing retrofit kit cable) purchased from ACAC before August 12, 2005 installed and less than 250 hours TIS since installation.
2000-25-02 R1American Champion Aircraft Corporation 7, 8, and 11 Series AirplanesJul 13, 2001Airframe (7ECA)Only with: Airplanes equipped with wood wing spars; Group 1 vs Group 2 depends on whether the engine has been modified to greater than 90 horsepower.

AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.

Service Difficulty Reports (0)

No Service Difficulty Reports found for this airframe since 1995.

Sources

  • FAA Aircraft RegistryRegistration, owner city and state, airframe, engineupdated Oct 18, 2026
  • NTSB accident and incident databaseAccidents and incidents since 1982updated Oct 15, 2026
  • FAA Airworthiness Directives (Federal Register)ADs published since 1998updated Oct 18, 2026
  • FAA Service Difficulty ReportsReports since 1995updated Oct 16, 2026

Request owner name removalReport an error in this record