Safety record in brief:1 NTSB accident (substantial damage, Jun 2001)3 ADs may apply1 service difficulty report
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Individual owners are shown by city and state only.
Unsuitable terrain for landing encountered by the pilot during the forced landing attempt. Factors relating to this accident were fuel starvation caused by foreign material blocking the fuel tank lines which led to the engine failure, annual inspection criteria not complied with, and the ditch.
From NTSB records; matched by serial number.Read NTSB report (search CAROL for CHI01LA189)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2009-22-02 | American Champion Aircraft Corp. Models 7ECA, 7GCAA, 7GCBC, 7KCAB, 8KCAB, and 8GCBC… | Dec 3, 2009 | Airframe (7KCAB)Only with: Manufactured prior to 1989 and equipped with folding rear seat backs. |
| 2005-24-10 | American Champion Aircraft Corporation Models 7AC, 7ACA, S7AC, 7BCM, 7CCM, S7CCM, 7DC… | Jan 17, 2006 | Airframe (7KCAB)Only with: Models 7ECA, 7GCAA, 7GCBC, 8KCAB, 8GCBC manufactured before August 12, 2005 with less than 250 hours TIS; or any listed model with a flight control cable (or wing retrofit kit cable) purchased from ACAC before August 12, 2005 installed and less than 250 hours TIS since installation. |
| 2000-25-02 R1 | American Champion Aircraft Corporation 7, 8, and 11 Series Airplanes | Jul 13, 2001 | Airframe (7KCAB)Only with: Airplanes equipped with wood wing spars; Group 1 vs Group 2 depends on whether the engine has been modified to greater than 90 horsepower. |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
DURING ANNUAL INSPECTION, IT WAS FOUND THAT ONE OF THE NAS BOLTS HOLDING THE IB END OF THE LANDING GEAR WAS TOO SHORT AND DID NOT GO ALL THE WAY THROUGH THE NAS NUT. THESE BOLTS WERE INSTALLED AT THE FACTORY, DURING A REPAIR IN 2001. FAILURE WOULD RESULT IN ONE LANDING GEAR LEG COLLAPSING.…
From FAA Service Difficulty Reports; matched by N-number and serial number.