Safety record in brief:1 NTSB accident (destroyed damage, Jun 2021)8 ADs may apply1 service difficulty report
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Individual owners are shown by city and state only.
The pilot’s failure to maintain helicopter control after an encounter with settling with power during approach at an altitude that was too low for recovery, which resulted in a hard landing.
From NTSB records; matched by serial number.Read NTSB report (search CAROL for WPR21LA236)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2014-03-10 | Various Restricted Category Helicopters | Mar 26, 2014 | Airframe (UH-1H)Only with: Restricted category helicopters with cable assembly part number 205-001-720-001 installed. |
| 2002-20-01 | Model HH-1K, TH-1F, TH-1L, UH-1A, UH-1B, UH-1E, UH-1F, UH-1H, UH-1L, and UH-1P; and… | Nov 6, 2002 | Airframe (UH-1H)Only with: Main rotor tension-torsion strap P/N 204-012-122-1, 204-012-122-5, 2601399, or 2606650 installed; manufactured by BHTI for the US Armed Forces. |
| 2002-13-51 | Model HH-1K, TH-1F, TH-1L, UH-1A, UH-1B, UH-1E, UH-1F, UH-1H, UH-1L, and UH-1P; and… | Aug 19, 2002 | Airframe (UH-1H)Only with: Tail rotor grip P/N 205-011-711-101 installed; helicopters manufactured by Bell for the U.S. Armed Forces. |
| 2002-01-31 | Model HH-1K, TH-1F, TH-1L, UH-1A, UH-1B, UH-1E, UH-1F, UH-1H, UH-1L, UH-1P, and… | Feb 1, 2002 | Airframe (UH-1H)Only with: Manufactured for the U.S. Armed Forces, with main rotor mast P/N 204-011-450-007, -105, or -109, or main rotor trunnion P/N 204-011-105-001 installed. |
| 2000-15-21 R1 | Bell Helicopter Textron Inc.-Manufactured Model HH-1K, TH-1F, TH-1L, UH-1A, UH-1B… | Nov 7, 2000 | Airframe (UH-1H)Only with: Manufactured by BHTI for the U.S. Armed Forces, with main rotor mast assembly P/N 204-011-450-001 or -005 installed. |
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2000-15-21 | Bell Helicopter Textron Inc.-Manufactured Model HH-1K, TH-1F, TH-1L, UH-1A, UH-1B… | Aug 9, 2000 | Airframe (UH-1H)Only with: Main rotor mast assembly P/N 205-011-450-001 or -005 installed. |
| 99-07-15 | Bell Helicopter Textron, Inc.- manufactured Model HH-1K, SW204, SW204HP, SW205… | May 3, 1999 | Airframe (UH-1H)Only with: Tail rotor yoke P/N 212-011-702 (all dash numbers), P/N 212-010-704 (all dash numbers), or P/N 212-010-744 (all dash numbers) installed. |
| 97-20-09 | Bell Helicopter Textron (Bell)- manufactured Model HH-1K, TH-1F, TH-1L, UH-1A, UH-1B… | May 28, 1998 | Airframe (UH-1H)Only with: Tailboom vertical fin spar P/N 205-032-899, 205-030-846, or 205-032-851, all dash numbers, installed. |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
DURING C/W ARMY BULLETIN 95-ASAM-05 ON STABILIZER BAR PIVOT BOLTS, THE NUTS WERE FOUND BOTTOMED OUT ON THE BOLT SHANK. NEW PARTS IAW ARMY PART MANUAL DID NOT PROPERLY SOLVE THE PROBLEM, HOWEVER, INSTALLATION OF BELL'S COMMERCIAL 205 BOLTS 20-057-10S27D AND SPECIAL WASHERS 140-007-41S38C4 WOULD…
From FAA Service Difficulty Reports; matched by N-number and serial number.