N2665Z1978 Bellanca 7GCAA
Safety record in brief:No NTSB accidents or incidents since 19823 ADs may apply1 service difficulty report
Registration
FAA Aircraft Registry · Oct 17, 2026- Registered owner
- Individual owner
- Certificate issued
- Sep 20, 2024
- Expires
- Sep 30, 2031
- Airworthiness
- Standard · Normal, Acrobatic
- Airworthiness date
- Jan 20, 1978
We never show street addresses, even though they appear in the public FAA file. Individual owners are shown by city and state only.
Airframe & engine
FAA Registry + type dataAirframe
- Manufacturer
- Bellanca
- Model
- 7GCAA
- Year
- 1978
- Serial number
- 351-78
- Aircraft type
- Fixed wing single engine
- Category
- Land
- Certification
- Type Certificated
- Seats
- 2
- Engines
- 1
- Max takeoff weight
- Up to 12,499 lb
- Mode S code
- A29866
Engine
- Make and model
- Lycoming 0-320 Series
- Type
- Reciprocating
- Power
- 180 hp
Total time and engine hours aren't public. They appear here once the owner adds logbooks.
Ownership history
Ownership history from FAA records- 2024 – nowIndividual ownercurrent
- until 1964Cessna Aircraft Companydifferent airframe: Cessna 185c S/N 185-0665
Individual owners are shown by city and state only.
Safety record
NTSB · Oct 15, 2026 · FAA ADs · Oct 17, 2026 · SDRs · Oct 16, 2026NTSB events (0)
No NTSB accidents or incidents found for this airframe since 1982.
Accident history for this modelADs published since 1998 that may apply (3)
These match the airframe or engine model. Whether each one applies, and whether it's been complied with, depends on serial numbers, equipment and logbook entries. Applicability must be confirmed by a mechanic against the aircraft's records.
| AD | Subject | Effective | Applies to |
|---|---|---|---|
| 2009-22-02 | American Champion Aircraft Corp. Models 7ECA, 7GCAA, 7GCBC, 7KCAB, 8KCAB, and 8GCBC… | Dec 3, 2009 | Airframe (7GCAA)Only with: Manufactured prior to 1989 and equipped with folding rear seat backs. |
| 2005-24-10 | American Champion Aircraft Corporation Models 7AC, 7ACA, S7AC, 7BCM, 7CCM, S7CCM, 7DC… | Jan 17, 2006 | Airframe (7GCAA)Only with: Models 7ECA, 7GCAA, 7GCBC, 8KCAB, 8GCBC manufactured before August 12, 2005 with less than 250 hours TIS; or any listed model with a flight control cable (or wing retrofit kit cable) purchased from ACAC before August 12, 2005 installed and less than 250 hours TIS since installation. |
| 2000-25-02 R1 | American Champion Aircraft Corporation 7, 8, and 11 Series Airplanes | Jul 13, 2001 | Airframe (7GCAA)Only with: Airplanes equipped with wood wing spars; Group 1 vs Group 2 depends on whether the engine has been modified to greater than 90 horsepower. |
AI-extracted — verify against original. Matched from each AD's applicability section; ADs replaced by a later AD are left out.
Service Difficulty Reports (1)
Reports of failures and defects that operators and repair stations sent to the FAA since 1995. A report describes one finding; it is not an accident.
- Flight controls · hinge · brokenMay 10, 2000
DURING WINDS OF APPROX 40 KNOTS, AILERON HINGE THAT ATTACHES TO CONTROL ROD TORE LOOSE FROM INBOARD END OF AILERON. FURTHER INVESTIGATION REVEALED THAT HINGE TABS, TOP AND BOTTOM, THAT ARE RIVETED ONTO SPAR CAPS HAD BROKEN PREVIOUSLY. THIS EVIDENCED BY THE STEEL HINGE BEING RUSTED AT THE BREAK.…
From FAA Service Difficulty Reports; matched by N-number and serial number.
Sources
- FAA Aircraft RegistryRegistration, owner city and state, airframe, engineupdated Oct 17, 2026
- NTSB accident and incident databaseAccidents and incidents since 1982updated Oct 15, 2026
- FAA Airworthiness Directives (Federal Register)ADs published since 1998updated Oct 17, 2026
- FAA Service Difficulty ReportsReports since 1995updated Oct 16, 2026